What it means
A07583 is the alarm “Encoder 3: Position actual value preprocessing error”. The drive raises it when an error occurs while it is preprocessing the position actual value of Encoder 3. No message value is output with this message, so there is no bit decoding to read. Depending on how the drive is configured, the same condition can also be output as fault F07583.
Why it appears
- An error occurred during the preprocessing of the position actual value of Encoder 3.
What to check
- Check the encoder that is used for the position actual value preprocessing.
- For S120 and S150 the manual additionally refers to p2502 (LR encoder assignment) — check the encoder assignment set there.
Parameters the manual names
- p2502 (LR encoder assignment / encoder assignment) — for this alarm, check which encoder is assigned here for the position actual value preprocessing; the manual names it under the remedy on S120 and S150.
Acknowledging and restarting
As an alarm, A07583 requires no acknowledgement. If the drive outputs the same condition as fault F07583 instead, it switches off with OFF1 (OFF2, OFF3) and the fault must be acknowledged immediately.
The same on every family
Every manual that describes A07583 gives it the same reaction, acknowledgement and message class.
| Drive family | Reaction | Acknowledge | Message class | Component | Manual |
|---|---|---|---|---|---|
| S120, S150 | NONE | NONE | Actual position/speed value incorrect or not available (11) | Encoder 3 | SINAMICS S120, S150 List Manual · p. 2852 |
| G130, G150 | NONE | NONE | Actual position/speed value incorrect or not available (11) | Encoder 3 | SINAMICS G130, G150 List Manual · p. 1586 |
The drives this code lives on
A07583 is described for G130, G150, S120, S150. These are the converters of those families in our catalogue — price on request.
Questions technicians ask
What does SINAMICS alarm A07583 mean?
It is the alarm “Encoder 3: Position actual value preprocessing error”: an error occurred while the drive was preprocessing the position actual value of Encoder 3. Depending on the configuration, the same condition can also appear as fault F07583.
How do I fix alarm A07583?
Check the encoder used for the position actual value preprocessing. On S120 and S150 the manual additionally points to p2502 (LR encoder assignment), so also check the encoder assignment set there.
Does A07583 have to be acknowledged?
No — as an alarm, A07583 requires no acknowledgement. If it is output as fault F07583, the drive switches off with OFF1 (OFF2, OFF3) and the fault must be acknowledged immediately.
Codes next to this one
Source
Written from Siemens' own List Manuals and operating instructions; every number, designation and parameter on this page is checked against them before publication.
All SINAMICS codes: fault and alarm codes · the A07xxx group · SINAMICS manuals · Siemens manuals