A01487 — Topology: Option slot component not inserted

A01487 is a topology alarm: the drive compares the actual topology (the hardware that is really connected) with the target topology (the project in the commissioning software) and has found that an option slot component expected by the project is not inserted. The message value names the component in the form Component: %1, to %2, %3, connection: %4. Which component is meant and where it belongs can be read from the alarm value in r2124; component class and connection number are described in F01375. Under Topology --> Topology view the commissioning software offers improved diagnostics capability where relevant, e.g. a setpoint/actual value comparison.

• The topology comparison has detected that an option slot component present in the target topology is missing in the actual topology, i.e. the component has not been inserted at the connection where the project expects it.

1. Insert the components involved at the right connection, so that the actual topology matches the project again.
2. Alternatively, adapt the project/parameterizing in the commissioning software, so that the target topology matches the hardware actually connected.
3. Check the 24 V supply voltage.
4. Check the DRIVE-CLiQ cables for interruption and contact problems.
5. Check that the component is working properly.

• The drive stores the alarm value in r2124; it must be interpreted hexadecimal, pattern ddccbbaa hex.
• dd = connection number (%4)
• cc = component number (%3)
• bb = component class (%2)
• aa = component number of the component that has not been inserted (%1)
• The component is described in dd, cc and bb, i.e. at the location where the component has not been inserted. Component class and connection number are described in F01375.

• r2124 — alarm value; read it as a hexadecimal ddccbbaa value to identify the missing option slot component, its class and the connection where it belongs.

No acknowledgment is required for this alarm. The remedy consists of inserting the component at the correct connection or adapting the project to the actual topology; once target and actual topology match again, no further reset action at the drive is needed.