F07501 — Drive: Motor Data Set MDS not configured

F07501 means that a drive data set refers to a motor data set (MDS) that has not been configured. The manual states this for power units: the motor data set was not configured, meaning that a data set number was not entered into the associated drive data set. Parameter p0186 is where a drive data set is given the number of its motor data set, so the fault is telling you that this entry is missing. Which drive data set is affected is shown in the message value (Drive data set: %1) and is contained in the fault value that the drive stores in r0949.

• Only for power units: the motor data set was not configured.
• Not configured here means that a data set number was not entered into the associated drive data set — p0186 is the parameter in which the drive data set receives the number of its motor data set.

1. Read the fault value in r0949 and interpret it decimal: the fault value includes the drive data set number of p0186, so it identifies the drive data set whose motor data set is missing.
2. Enter the index of the motor data set associated with this drive data set into p0186.

• The drive stores the fault value in r0949; the manual says to interpret it decimal.
• The fault value includes the drive data set number of p0186.
• The message value is printed as Drive data set: %1, so %1 is the affected drive data set.

• r0949 (Fault value): read the fault value here and interpret it decimal to obtain the drive data set number concerned by F07501.
• p0186 (Motor Data Sets (MDS) number): enter here the index of the motor data set that belongs to the affected drive data set — this is the remedy for the fault.

The fault trips the drive with OFF2, so the motor coasts down. After the index of the motor data set has been entered into p0186, acknowledge the fault immediately; the drive can then be started again.