What it means
A35054 is an alarm of the TM54F Terminal Module: the temperature measured using the temperature sensing on the TM54F has exceeded the threshold value at which the drive initiates this alarm. The manuals for the G130, G150, S120 and S150 describe the message with the same wording — in every case it is the temperature sensing of the Terminal Module itself that has crossed the alarm threshold.
Why it appears
- The temperature sensed by the temperature sensing on the TM54F rose above the threshold value that initiates this alarm.
What to check
- Allow the TM54F to cool down.
- Carry out the safe acknowledgment via p10006.
Parameters the manual names
- p10006 — SI Motion acknowledgment internal event F-DI (processor 1): the parameter through which the safe acknowledgment is carried out once the TM54F has cooled down.
Acknowledging and restarting
No acknowledgment of the message itself is required. After the TM54F has cooled down, carry out the safe acknowledgment — the manuals name p10006 for this step.
The same on every family
Every manual that describes A35054 gives it the same reaction, acknowledgement and message class.
| Drive family | Reaction | Acknowledge | Message class | Component | Manual |
|---|---|---|---|---|---|
| S120, S150 | NONE | NONE | Overtemperature of the electronic components (6) | Terminal Module (TM) | SINAMICS S120, S150 List Manual · p. 3208 |
| G130, G150 | NONE | NONE | Overtemperature of the electronic components (6) | Terminal Module (TM) | SINAMICS G130, G150 List Manual · p. 1876 |
The drives this code lives on
A35054 is described for G130, G150, S120, S150. These are the converters of those families in our catalogue — price on request.
Questions technicians ask
What does alarm A35054 mean on a SINAMICS drive?
It is an alarm of the TM54F Terminal Module: the temperature measured using the temperature sensing on the TM54F has exceeded the threshold value at which this alarm is initiated.
How do I clear A35054?
Allow the TM54F to cool down and then carry out the safe acknowledgment via p10006. A message acknowledgment is not required.
Which parameter is used for the safe acknowledgment after A35054?
p10006, the SI Motion acknowledgment internal event F-DI (processor 1). The remedy for this alarm names it as the way to carry out the safe acknowledgment.
Codes next to this one
Source
Written from Siemens' own List Manuals and operating instructions; every number, designation and parameter on this page is checked against them before publication.
All SINAMICS codes: fault and alarm codes · the A35xxx group · SINAMICS manuals · Siemens manuals