What it means
F36214 signals that the 24 V power supply on the DRIVE-CLiQ Hub Module has exceeded the fault threshold. The module monitors its own 24 V supply and raises the code as soon as the measured operating voltage crosses that limit. Depending on how the drive is configured, the same condition can also be output as an alarm or without any reaction.
Why it appears
- The 24 V power supply on the DRIVE-CLiQ Hub Module has risen above the fault threshold.
What to check
- Check the supply voltage of the component involved.
- Replace the component involved.
Reading the message value
- The drive stores the fault value in r0949; interpret the stored number as a decimal value.
- Contents:
Actual operating voltage in 0.1 °C resolution
— the operating voltage measured on the Hub Module's 24 V supply at the moment the code was raised.
Parameters the manual names
- r0949 — fault value of this code: read here which operating voltage the Hub Module measured on its 24 V supply; the value is to be read as a decimal number.
Acknowledging and restarting
Acknowledge the fault immediately once the supply voltage has been corrected. Switching the supply voltage off and on again (POWER ON) also clears the code. The drive does not trigger a stop reaction of its own when the fault is raised.
The same on every family
Every manual that describes F36214 gives it the same reaction, acknowledgement and message class.
| Drive family | Reaction | Acknowledge | Message class | Component | Manual |
|---|---|---|---|---|---|
| S120, S150 | NONE (OFF1, OFF2) | IMMEDIATELY (POWER ON) | Supply voltage fault (overvoltage) (3) | Terminal Board (TB) | SINAMICS S120, S150 List Manual · p. 3250 |
| G130, G150 | NONE (OFF1, OFF2) | IMMEDIATELY (POWER ON) | Supply voltage fault (overvoltage) (3) | Terminal Board (TB) | SINAMICS G130, G150 List Manual · p. 1912 |
The drives this code lives on
F36214 is described for G130, G150, S120, S150. These are the converters of those families in our catalogue — price on request.
Questions technicians ask
What does fault F36214 mean on a SINAMICS drive?
The 24 V power supply on the DRIVE-CLiQ Hub Module has exceeded the fault threshold. Depending on the drive configuration, the same condition can also be output as an alarm or without any reaction.
How do I clear fault F36214?
Acknowledge the fault immediately; switching the supply voltage off and on again (POWER ON) also clears it. The remedy is to check the supply voltage of the component involved and to replace the component involved.
What is stored in r0949 for F36214?
The fault value — the actual operating voltage of the 24 V supply, given <q>in 0.1 °C resolution</q> as the manual prints it. Read r0949 as a decimal number.
Does F36214 stop the drive?
No automatic stop reaction is triggered when this fault is raised. The drive keeps running and signals the overvoltage on the Hub Module's 24 V supply.
Codes next to this one
Source
Written from Siemens' own List Manuals and operating instructions; every number, designation and parameter on this page is checked against them before publication.
All SINAMICS codes: fault and alarm codes · the F36xxx group · SINAMICS manuals · Siemens manuals