What it means
The TM54F raises fault F35011 when a drive object number has been assigned twice. Each drive object number can be assigned only once, so a number that appears a second time is an illegal assignment. The manuals for G130, G150, S120 and S150 describe this message identically.
Why it appears
- One and the same drive object number was assigned twice — every drive object number may be assigned only once.
What to check
- Open p10010 (SI TM54F drive object assignment) and find the drive object number that has been entered a second time.
- Correct the assignment of the drive object numbers so that each number is used only once.
- Switch the drive power off and on afterwards to acknowledge the fault (see below).
Parameters the manual names
- p10010 — SI TM54F drive object assignment (SI DO assign): the parameter in which the drive object numbers of the TM54F are set; this is where the duplicated number must be corrected to clear F35011.
Acknowledging and restarting
Once the drive object number assignment has been corrected, the fault is acknowledged by switching the drive power off and on again (POWER ON).
The same on every family
Every manual that describes F35011 gives it the same reaction, acknowledgement and message class.
| Drive family | Reaction | Acknowledge | Message class | Component | Manual |
|---|---|---|---|---|---|
| S120, S150 | NONE | IMMEDIATELY (POWER ON) | Error in the parameterization / configuration / commissioning procedure (18) | None | SINAMICS S120, S150 List Manual · p. 3201 |
| G130, G150 | NONE | IMMEDIATELY (POWER ON) | Error in the parameterization / configuration / commissioning procedure (18) | None | SINAMICS G130, G150 List Manual · p. 1870 |
The drives this code lives on
F35011 is described for G130, G150, S120, S150. These are the converters of those families in our catalogue — price on request.
Questions technicians ask
What does SINAMICS fault F35011 mean?
The TM54F has detected that a drive object number was assigned twice. Each drive object number can be assigned only once, so a duplicate assignment is reported as illegal.
How do I fix fault F35011?
Correct the assignment of the drive object numbers — the manual points to p10010 (SI TM54F drive object assignment) — and then switch the drive power off and on again.
Which parameter belongs to F35011?
p10010, the SI TM54F drive object assignment. This is the parameter in which the duplicated drive object number has to be corrected.
Codes next to this one
Source
Written from Siemens' own List Manuals and operating instructions; every number, designation and parameter on this page is checked against them before publication.
All SINAMICS codes: fault and alarm codes · the F35xxx group · SINAMICS manuals · Siemens manuals