What it means
F01014 is one of the topology messages and reports that the properties of a DRIVE-CLiQ component have fundamentally changed — the component present in the drive topology no longer has the properties the drive expects of it. The drive stores the number of the affected component in the fault value r0949, which is interpreted hexadecimal; the message value shows the same number as “Component number”.
Why it appears
- The properties of a connected DRIVE-CLiQ component have fundamentally changed.
What to check
- Check the DRIVE-CLiQ component, and replace it if required.
- Carry out a warm restart: set p0009 = 30 and trigger it with p0976 = 2 or 3.
Reading the message value
- Fault value (r0949, interpret hexadecimal): component number — the drive writes the number of the affected DRIVE-CLiQ component into r0949.
- Message value: “Component number: %1” — %1 is the component number of the DRIVE-CLiQ component whose properties changed.
Parameters the manual names
- r0949 — fault value: read it hexadecimal to find the number of the component that raised F01014.
- p0009 — device commissioning parameter filter: set it to 30 as part of the warm restart.
- p0976 — reset and load all parameters: set it to 2 or 3 to trigger the warm restart.
Acknowledging and restarting
The fault must be acknowledged immediately; the drive itself takes no automatic action when it is raised. If the fault reappears, follow the checks above and then carry out a warm restart (p0009 = 30, p0976 = 2, 3)
.
The same on every family
Every manual that describes F01014 gives it the same reaction, acknowledgement and message class.
| Drive family | Reaction | Acknowledge | Message class | Component | Manual |
|---|---|---|---|---|---|
| S120, S150 | NONE | IMMEDIATELY | Hardware/software error (1) | None | SINAMICS S120, S150 List Manual · p. 2560 |
The drives this code lives on
F01014 is described for S120, S150. These are the converters of those families in our catalogue — price on request.
Questions technicians ask
What does fault F01014 mean on a SINAMICS drive?
It reports that the properties of a DRIVE-CLiQ component have fundamentally changed. The fault value in r0949, interpreted hexadecimal, contains the component number of the affected component.
How do I fix F01014?
Check the DRIVE-CLiQ component and replace it if required, then carry out a warm restart with p0009 = 30 and p0976 = 2 or 3. The fault itself is acknowledged immediately.
Where can I see which component triggered F01014?
Read r0949 and interpret the value hexadecimal — it holds the component number. The message value also displays it as “Component number”.
Does F01014 stop the drive?
No, the drive takes no automatic action when this fault is raised. It still has to be acknowledged immediately.
Codes next to this one
Source
Written from Siemens' own List Manuals and operating instructions; every number, designation and parameter on this page is checked against them before publication.
All SINAMICS codes: fault and alarm codes · the F01xxx group · SINAMICS manuals · Siemens manuals