What it means
A07497 is an alarm that reports the active LR position actual value setting: while the binector input p2514 carries a 1 signal, the position actual value is set to the value received via connector input p2515. The drive raises the alarm so this state is visible, because while the setting is active a possible system deviation cannot be corrected. Depending on the drive's configuration, the condition can also be issued with no reaction (N).
Why it appears
- The binector input p2514 carries a 1 signal, so the position actual value is set to the value received via connector input p2515.
- While the setting is active, a possible system deviation cannot be corrected.
What to check
- No measures are necessary — the alarm only reports that the setting function is active.
- If the position actual value should not be set, return the binector input p2514 to the 0 signal; the alarm then disappears automatically.
Parameters the manual names
- p2514 — binector input that activates the LR position actual value setting; the alarm is present while it is 1 and withdraws automatically when it returns to 0.
- p2515 — connector input supplying the value that the position actual value is set to while p2514 = 1.
Acknowledging and restarting
No acknowledgement is required. The alarm withdraws itself automatically as soon as the binector input p2514 returns to the 0 signal.
The same on every family
Every manual that describes A07497 gives it the same reaction, acknowledgement and message class.
| Drive family | Reaction | Acknowledge | Message class | Component | Manual |
|---|---|---|---|---|---|
| S120, S150 | NONE | NONE | Application/technological function faulted (17) | None | SINAMICS S120, S150 List Manual · p. 2831 |
| G130, G150 | NONE | NONE | Application/technological function faulted (17) | None | SINAMICS G130, G150 List Manual · p. 1568 |
The drives this code lives on
A07497 is described for G130, G150, S120, S150. These are the converters of those families in our catalogue — price on request.
Questions technicians ask
What does alarm A07497 mean on SINAMICS?
It reports that the LR position actual value setting is active: while binector input p2514 = 1, the position actual value is set to the value received via connector input p2515. A possible system deviation cannot be corrected while this is active.
How do I clear alarm A07497?
No acknowledgement is needed. The alarm disappears automatically as soon as the binector input p2514 returns to the 0 signal.
Is A07497 a drive fault?
No — the manuals list it as an alarm for which no remedy is necessary; it only reports the active setting function. Depending on the drive's configuration it can also be issued with no reaction (N).
Why can no system deviation be corrected?
Because while p2514 = 1 the position actual value is set to the value at p2515, and in this state a possible system deviation cannot be corrected.
Codes next to this one
Source
Written from Siemens' own List Manuals and operating instructions; every number, designation and parameter on this page is checked against them before publication.
All SINAMICS codes: fault and alarm codes · the A07xxx group · SINAMICS manuals · Siemens manuals