What it means
The drive shows A01306 while the firmware of at least one connected DRIVE-CLiQ component is being updated. The alarm reports a process in progress and disappears again on its own once the update is finished. Neighbouring alarms in the same group (A01304, A01302, A01314, A01317, A01318, A01319, A01320, A01321) cover other DRIVE-CLiQ component and topology conditions and are described on their own pages.
Why it appears
- A firmware update is currently running on at least one DRIVE-CLiQ component.
What to check
- Nothing has to be done. Wait until the drive has finished writing the firmware; the alarm is then withdrawn automatically.
Reading the message value
- The alarm value contains the component number of the DRIVE-CLiQ component whose firmware is being updated. The drive stores it in r2124, and it is to be interpreted as a decimal number.
Parameters the manual names
- r2124 — the alarm value of this code; read it as a decimal number to identify the DRIVE-CLiQ component that is currently being updated.
Acknowledging and restarting
No acknowledgement is required. The alarm withdraws itself automatically as soon as the firmware update of the DRIVE-CLiQ component has completed.
The same on every family
Every manual that describes A01306 gives it the same reaction, acknowledgement and message class.
| Drive family | Reaction | Acknowledge | Message class | Component | Manual |
|---|---|---|---|---|---|
| S120, S150 | NONE | NONE | General drive fault (19) | None | SINAMICS S120, S150 List Manual · p. 2588 |
| G130, G150 | NONE | NONE | General drive fault (19) | None | SINAMICS G130, G150 List Manual · p. 1399 |
The drives this code lives on
A01306 is described for G130, G150, S120, S150. These are the converters of those families in our catalogue — price on request.
Questions technicians ask
What does A01306 mean on a SINAMICS G130, G150, S120 or S150?
The firmware of at least one DRIVE-CLiQ component is currently being updated. The alarm belongs to the update process and disappears by itself when the update is finished.
How do I acknowledge or reset alarm A01306?
You do not need to do anything. The alarm is withdrawn automatically once the firmware update of the DRIVE-CLiQ component has completed.
How can I find out which component A01306 refers to?
Read the alarm value in r2124 as a decimal number. It contains the component number of the DRIVE-CLiQ component being updated.
Codes next to this one
Source
Written from Siemens' own List Manuals and operating instructions; every number, designation and parameter on this page is checked against them before publication.
All SINAMICS codes: fault and alarm codes · the A01xxx group · SINAMICS manuals · Siemens manuals