What it means
F05060 is raised when power units are connected in parallel and a power unit in the parallel circuit does not carry the firmware required for this connection. The manuals give V02.30.01.00 as the version from which firmware is required when power units are connected in parallel.
Why it appears
- Connecting the power units in parallel requires firmware from version V02.30.01.00, and one of the paralleled power units does not run firmware from this version.
What to check
- Update the firmware of the power units in the parallel circuit to at least V02.30.01.00, so that every paralleled power unit meets the required version.
Reading the message value
- The drive stores the parameter concerned in the message value; the manual prints it as the placeholder %1.
Acknowledging and restarting
Acknowledge the fault once the firmware of all power units in the parallel circuit has been updated to at least V02.30.01.00; acknowledging clears the message.
The same on every family
Every manual that describes F05060 gives it the same reaction, acknowledgement and message class.
| Drive family | Reaction | Acknowledge | Message class | Component | Manual |
|---|---|---|---|---|---|
| S120, S150 | OFF2 | IMMEDIATELY | Error in the parameterization / configuration / commissioning procedure (18) | Power Module | SINAMICS S120, S150 List Manual · p. 2751 |
| G130, G150 | OFF2 | IMMEDIATELY | Error in the parameterization / configuration / commissioning procedure (18) | Power Module | SINAMICS G130, G150 List Manual · p. 1524 |
The drives this code lives on
F05060 is described for G130, G150, S120, S150. These are the converters of those families in our catalogue — price on request.
Questions technicians ask
What firmware version does fault F05060 require in the parallel circuit?
Power units connected in parallel must run firmware from version V02.30.01.00. F05060 is raised when a power unit in the circuit does not meet this requirement.
How do I clear fault F05060?
Update the firmware of the power units so that the whole parallel circuit runs at least V02.30.01.00, then acknowledge the fault.
Which SINAMICS drives can report F05060?
The fault is described for SINAMICS G130, G150, S120 and S150, and it refers to power units connected in a parallel circuit.
What does the message value of F05060 contain?
It holds the parameter the message refers to; the manual prints it as the placeholder %1.
Codes next to this one
Source
Written from Siemens' own List Manuals and operating instructions; every number, designation and parameter on this page is checked against them before publication.
All SINAMICS codes: fault and alarm codes · the F05xxx group · SINAMICS manuals · Siemens manuals