A07465 — EPOS: Traversing block does not have a subsequent block

A07465 is an EPOS alarm. It reports that a traversing block does not have a subsequent block: the block change from this traversing block finds no following block that has been parameterized. The drive takes no automatic reaction to this alarm and no acknowledgement is needed — the alarm points at the traversing block parameterization, and its alarm value names the affected block.

• A traversing block has no subsequent block: the block change from this block would have to continue into a following traversing block, but none has been parameterized.
• The traversing block is not parameterized with the block change enable END, which would let it terminate the block sequence.

1. Read the alarm value in r2124 and interpret it as a decimal number — it is the number of the traversing block with the missing subsequent block.
2. Parameterize this traversing block with the block change enable END.
3. Alternatively, parameterize additional traversing blocks with a higher block number, and give the last of these blocks the block change enable END.

• The drive outputs the message value %1 as the alarm value; it is stored in r2124.
• Interpret the alarm value as a decimal number.
• The value is the number of the traversing block with the missing subsequent block.

• r2124 (alarm value) — read here which traversing block is affected: the value, interpreted as a decimal number, is the number of the traversing block with the missing subsequent block.

No acknowledgement is required. The alarm concerns the traversing block parameterization: once the block named in the alarm value either ends with the block change enable END or its missing subsequent blocks have been parameterized, the condition reported by the alarm no longer exists.