Файл за старою адресою не зберігся. Нижче — документ виробника на те саме обладнання.
| Вид документа | Каталожна сторінка |
|---|---|
| Виробник | JCI |
| Моделі | m9102-aga-2s, m9102-aga-3s, m9102-iga-2s, m9102-iga-3s, m9104-aga-2s, m9104-aga-3s, m9104-iga-2s, m9104-iga-3s |
| Група обладнання | automation |
| Мова документа | англійська |
| Розмір файлу | 0.5 МБ |
Про документ
Non-spring return electric damper actuators for zone damper applications in HVAC systems. The M9102–M9104 series provides 18 lb-in (2 Nm) and 35 lb-in (4 Nm) torque with on-off, floating and proportional control inputs; the M910x-AGx-2Nx series covers 35 lb-in (4 Nm) and 53 lb-in (6 Nm) with adjustable rotational range and floating control.
Ключові дані
| torque rating | 18 lb-in (2 Nm), 35 lb-in (4 Nm) and 53 lb-in (6 Nm) |
|---|---|
| supply voltage | AC 24 V 50/60 Hz |
| running time at 60 Hz | 15, 30, 60, 90 or 120 sec (model dependent) |
| ambient temperature rating | -4 to 125°F (-20 to 52°C) |
| rotation range | 93 degrees CW or CCW (M9102–M9104); adjustable 30 or 90 degrees CW or CCW (AGx-2Nx) |
| noise rating | 35 dBA |
| cycle/reposition rating | 100,000 full stroke cycles; 1,500,000 repositioning (2 Nm/4 Nm) or 2,500,000 repositioning (AGx-2Nx) |
| shaft fit | 3/8 to 1/2" (10 to 13 mm) round or 3/8" (10 mm) square shaft |
Застосування
- Zone damper actuator applications
- On-off, floating and proportional control of dampers
Особливості
- Simple direct coupling reduces installation and commissioning time; single screw coupling provides three-point shaft gripping
- Small, compact design for tight-fitting locations
- Long life brushless synchronous drive motor — constant running time independent of load
- Whisper quiet 35 dBA noise rating
- Magnetic clutch provides over torque protection over the entire range of rotation
- Manual gear release simplifies setup and field adjustments
- Proportional models are dip switch selectable for DA/RA and DC 0…10 V or DC 2…10 V control
- GGX models offer position feedback for closed-loop operation
- DC 0(4) … 20 mA proportional control with optional 500 Ohm resistor
- Adjustable rotation stops allow 30 to 90° clockwise or counterclockwise rotation (AGx-2Nx series)
Технічні дані
| Parameter | Value |
|---|---|
| Torque ratings | 18 lb-in (2 Nm); 35 lb-in (4 Nm); 53 lb-in (6 Nm) |
| Supply voltage | AC 24 V 50/60 Hz |
| Running time at 60 Hz | 30 sec (M9102/M9104 -AGA/-IGA); 60 sec (M9104 -GGA, M9106-AGA-2N01); 120 sec (M9106-AGA-2N02); 90 sec (M9104-AGA-2N); 15, 30, 60 and 90 sec selectable (AGx-2Nx series) |
| Rotation range | 93 degrees CW or CCW (M9102–M9104); adjustable 30 or 90 degrees CW or CCW (AGx-2Nx) |
| Ambient temperature | -4 to 125°F (-20 to 52°C) |
| Noise rating | 35 dBA |
| Full stroke cycle / reposition | 100,000 full stroke cycles, 1,500,000 repositions (2 Nm / 4 Nm); 100,000 full stroke cycles, 2,500,000 repositions (AGx-2Nx) |
| Shaft fit | 3/8 to 1/2" (10 to 13 mm) round or 3/8" (10 mm) square shaft |
| Control inputs | On-off, floating; DC 0(2)…10 V proportional; DC 0(4)…20 mA with optional 500 Ohm resistor |
| Wiring | 48 in. (1.2 m) 18 AWG UL CMP plenum cable or M3 screw terminals |
| Auxiliary switches | None; AGS models include DPT-2015 and CBL-2000-1 |
Варіанти замовлення
- m9102-aga-2s / m9102-aga-3s: floating, no timeout, 18 lb-in (2 Nm), 30 sec @ 60 Hz, plenum cable / M3 screw terminals
- m9102-iga-2s / m9102-iga-3s: on-off/floating with timeout, 18 lb-in (2 Nm), plenum cable / M3 screw terminals
- m9104-aga-2s / m9104-aga-3s: floating, no timeout, 35 lb-in (4 Nm), 60 sec @ 60 Hz, plenum cable / M3 screw terminals
- m9104-iga-2s / m9104-iga-3s: on-off/floating with timeout, 35 lb-in (4 Nm), plenum cable / M3 screw terminals
- m9104-gga-2s / m9104-gga-3s: DC 0(2)…10 V proportional, plenum cable / M3 screw terminals
- m9104-aga-2n: floating, 35 lb-in (4 Nm), 90 sec @ 60 Hz
- m9104-ags-2n: includes DPT-2015 and CBL-2000-1
- m9106-aga-2n01: 53 lb-in (6 Nm), 60 sec @ 60 Hz
- m9106-aga-2n02: 53 lb-in (6 Nm), 120 sec @ 60 Hz
- m9106-ags-2n02: includes DPT-2015 and CBL-2000-1
Допуски та стандарти
- cULus Listed, CE Mark (M9102–M9104 series)
- UL Listed, CSA Certified, CE Mark (M910x-AGx-2Nx series)
Позиції каталогу з цим документом
Текст документа
Valve Assemblies
2 to 4 nm (18 to 35 lb-in) Non-spring return damper actuators selection guide
M9102 - M9104 Series Damper Actuators
m9102 - M9104 Series
Ball Valve
•Simple direct coupling reduces installation • Long life brushless synchronous drive motor
and commissioning time and improves technology – provides constant running
reliability by eliminating damper linkages. time independent of load
Single screw coupling provides three-point
• Robust 18 lb-in (2 Nm) and 35 lb-in (4 Nm)
shaft gripping
torque rating
• Small, compact design — allows installation
• Whisper quiet 35 dBA noise rating
in tight-fitting locations designed for zone
damper actuator applications • Magnetic clutch – provides over torque
protection over the entire range of rotation
• Rotation range 93 degrees CW or CCW
• -4 to 125°F (-20 to 52°C) ambient
• Fits 3/8 to 1/2” (10 to 13 mm) round or 3/8”
temperature rating
(10 mm) square shaft
• 100,000 full stroke cycle, 1,500,000
• On-off, floating and proportional control
Electric Actuators
reposition rating
inputs
• Manual gear release simplifies setup and
• Proportional models are dip switch selectable
field adjustments position feedback (GGX
for DA / RA and DC 0…10 V or DC 2…10 V
models) provides simple, closed-loop
operation
control with accurate position sensing.
• DC 0(4) ... 20 mA proportional control
• cULus Listed, CE Mark
w/optional 500 Ohm resistor
• Models available with 30 or 60 second
running time at 60 Hz
Humidity Sensors
m9102 - m9104 series non-spring return damper actuators
code number control type torque/timing/voltage auxiliary switches comments
floating 18 lb-in (2 nm)
m9102-aga-2s none 48 in. (1.2 m) 18 awg ul cmp plenum cable
without timeout 30 sec timing at 60 hz
ac 24 v 50/60 hz
m9102-aga-3s m3 screw terminals
on-off / floating
m9102-iga-2s 48 in. (1.2 m) 18 awg ul cmp plenum cable
with timeout
m9102-iga-3s m3 screw terminals
floating 35 lb-in (4 nm)
m9104-aga-2s 48 in. (1.2 m) 18 awg ul cmp plenum cable
without timeout 60 sec timing at 60 hz
Dampers
ac 24 v 50/60 hz
m9104-aga-3s m3 screw terminals
on-off / floating
m9104-iga-2s 48 in. (1.2 m) 18 awg ul cmp plenum cable
with timeout
m9104-iga-3s m3 screw terminals
dc 0(2) . . . 10 v
m9104-gga-2s 48 in. (1.2 m) 18 awg ul cmp plenum cable
proportional
m9104-gga-3s m3 screw terminals
4 to 6 nm (35 to 53 lb-in) Non-spring return damper actuators selection guide
M910x - AGx - 2Nx Series Damper Actuators
m910x - AGx - 2Nx Series
•Simple direct coupling reduces installation • Robust 35 lb-in (4 Nm) and 53 lb-in (6 Nm)
and commissioning time and improves torque ratings
reliability by eliminating damper linkages.
• Whisper quiet 35 dBA noise rating
Single screw coupling provides three-point
shaft gripping • Magnetic clutch – provides over torque
protection over the entire range of rotation
• Designed for zone damper applications
• 35 to 125°F (-20 to 52°C) ambient
• Small, compact design — allows installation
temperature rating
in tight-fitting locations
• 100,000 full stroke cycle, 2,500,000
• Adjustable 30 or 90 degrees CW or CCW
reposition rating
rotational range
• Manual gear release simplifies setup
• Fits 3/8 to 1/2” (10 to 13 mm) round or 3/8”
and field adjustments
(10 mm) square shaft
• Adjustable rotation stops allow application
• Floating
versatility with 30 to 90° clockwise or
• 15, 30, 60 and 90 second running time counterclockwise rotation
at 60 Hz
• UL Listed, CSA Certified, CE Mark
• Long life brushless synchronous drive motor
technology – provides constant running
time independent of load
m910x - agx - 2nx series non-spring return damper actuators
code number control type torque/timing/voltage auxiliary switches comments
35 lb-in (4 nm)
m9104-aga-2n floating none
90 sec timing at 60 hz
ac 24 v 50/60 hz
actuator includes a
m9104-ags-2n
dpt-2015 and cbl-2000-1
m9106-aga-2n01 53 lb-in (6 nm) actuator only
60 sec timing at 60 hz
ac 24 v 50/60 hz
m9106-aga-2n02 53 lb-in (6 nm)
120 sec timing at 60 hz
ac 24 v 50/60 hz
m9106-ags-2n02 actuator includes a
dpt-2015 and cbl-2000-1
© 2007 Johnson Controls, Inc. P.O. Box 423, Milwaukee, WI 53201 Printed in USA PUBL-4091 www.johnsoncontrols.com
Документ виробника, опублікований як довідковий матеріал на обладнання, яке ми постачаємо. Правовласник може попросити прибрати його — приберемо.