| Вид документа | Технічний бюлетень |
|---|---|
| Виробник | JCI |
| Код документа | m9116-agx-2-series-on-off-and-floating-control-electric-non-spring-return |
| Група обладнання | DMPR-KC003 Blade Pin Extension |
| Сторінок | 4 |
| Мова документа | англійська |
| Розмір файлу | 0.1 МБ |
Текст документа
M9116-AGx-2 Series On/Off and Floating Control
Electric Non-Spring-Return Actuators
Product Bulletin Code No. LIT-1201461
Issued October 2017
The M9116-AGx-2 Series direct-mount electric
actuators operate on 24 VAC or VDC power and are
available for use with on/off or floating controllers.
These bidirectional actuators do not require a damper
linkage and are easily installed on a damper with a
round shaft up to 3/4 in. (19 mm) or a square shaft up
to 5/8 in. (16 mm) in diameter. They may be direct- or
remote-mounted to a damper or mounted to a valve
using the M9000-500 Valve Linkage Kit.
A single M9116 model delivers up to 140 lb·in (16 N·m)
of torque. The angle of rotation is mechanically
adjustable from 0 to 90° in 5 degree increments.
Integral auxiliary switches are available to indicate
end-stop position or to perform switching functions at
any angle within the selected rotation range. Position
feedback is available through either a 135 or a 1,000
ohm potentiometer. Figure 1: M9116 Series Actuator
Table 1: Features and Benefits
Features Benefits
Output Position Feedback Provides simple, closed-loop control with accurate position sensing.
Electronic Stall Detection Ensures higher reliability by deactivating the actuator motor when a stall
condition is detected.
Dual Scale (0 to 90° and 90 to 0°) on the Indicates the position of the actuator’s rotation in 10° increments.
Cover
Removable Coupler Allows adjustment of the rotation range from 0 to 90°.
Steel U-bolt Clamp Provides four-point damper shaft gripping.
Manual Gear Release Simplifies installation, setup, and field adjustments.
National Pipe Thread (NPT) Threaded Provides easy connection for electrical fittings.
Housing
M9116-AGx-2 Series On/Off and Floating Control Electric Non-Spring-Return Actuators 1
Product Bulletin
Application Operation
IMPORTANT: This device is not designed or IMPORTANT: Use this M9116-AGx-2 Series
intended to be used in or near environments where electric actuator only to control equipment under
explosive vapors or gases could be present, or normal operating conditions. Where failure or
environments where substances corrosive to the malfunction of the actuator could lead to personal
device’s internal components could be present. injury or property damage to the controlled
equipment or other property, additional precautions
M9116-AGx-2 actuators are designed to position air must be designed into the control system.
dampers and valves in HVAC systems. Applications Incorporate and maintain other devices, such as
include: supervisory or alarm systems or safety or limit
controls, intended to warn of or protect against
• positioning return air or exhaust dampers failure or malfunction of the actuator.
• controlling face and bypass dampers
M9116 actuators operate on 24 VAC at 50/60 Hz or
• positioning blades for variable volume fans
24 VDC. These compact actuators use a DC motor
• positioning VG1000 Series ball valves and with stall detection circuitry that operates throughout
VG7000 Series globe valves when used with the the entire stroke.
M9000-500 Valve Linkage
Rotation is mechanically limited to 93° by integral
Refer to the manufacturer’s information to properly size end-stops. The position of the actuator is marked from
the damper, valve, or actuator. Spring-return actuators, 0 to 90° on the cover. An anti-rotation bracket prevents
such as Johnson Controls® M9206 and M9216 Series, lateral movement of the actuator. Press the
are recommended for use with outdoor air dampers in spring-loaded gear release on the actuator cover to
cold climates. disengage the gear train for manual repositioning of the
coupler.
Dimensions
See Figure 2 for actuator dimensions.
3.94 Shaft 1.04
100 Dimensions 27
0.37 to 0.63 5.75
1.38 146
10 to 16
35
90 0 0.37 to 0.8
7.09 60 30 10 to 20
0 90
180 30 Shaft
60 5.43
Dimensions Cover 1.88
4.92 138 48
Removal
125 2.13
54
3.13
79
4.88
1.73 1.38 124
35 1.22
44 Anti-rotation Bracket
Conduit Plug Centers 2.54
64.5 Dimensions
Figure 2: Actuator and Anti-Rotation Bracket Dimensions, in. (mm)
2 M9116-AGx-2 Series On/Off and Floating Control Electric Non-Spring-Return Actuators Product Bulletin
Ordering Information
Table 2: Actuator Models and Accessories
Product Description
Code
Number
M9116-AGA-2 140 lb·in (16 N·m) electric non-spring-return actuator for on/off or floating control with 24 VAC/VDC input
M9116-AGC-2 140 lb·in (16 N·m) electric non-spring-return actuator for on/off or floating control with 24 VAC/VDC input
and two SPDT 24 VAC auxiliary switches
M9116-AGD-2 140 lb·in (16 N·m) electric non-spring-return actuator for on/off or floating control with 24 VAC/VDC input
and a 135 ohm feedback potentiometer
M9116-AGE-2 140 lb·in (16 N·m) electric non-spring-return actuator for on/off or floating control with 24 VAC/VDC input
and a 1k ohm feedback potentiometer
DMPR-KR0031 Sleeve Pin Kit for Johnson Controls round dampers with a 5/16 in. (8 mm) diameter shaft
DMPR-KC0031 Blade Pin Extension without Bracket for Johnson Controls D-1300 direct-mount applications
DMPR-KC254 Inside Frame Mounting Kit for damper applications requiring the actuator within the airstream
M9000-103 14 VA Transformer, 120/24 VAC, 60 Hz, Class 2
M9000-104 14 VA Transformer, 230/24 VAC, 60 Hz, Class 2
M9000-105 Pluggable 3-terminal block
M9000-150 Damper Mount Linkage Kit for remote inside duct mounting an M9116 actuator to a 3-blade or larger
damper (not intended for a Johnson Controls damper)
M9000-151 Base Mount Linkage Kit for remote inside duct mounting
M9000-153 Crank Arm Kit for remote mounting
M9000-154 1 in. Jackshaft Coupler Kit for mounting on a 1 in. diameter damper shaft
M9000-155 Manual Handle for positioning a damper or valve when power is removed from an M91xx actuator
M9000-160 Replacement anti-rotation bracket for M91xx Series actuators
M9000-500 Valve Linkage Kit for mounting M9116 actuators to 1/2 to 2 in. VG7000 Series globe valves
1. Furnished with the damper and may be ordered separately.
M9116-AGx-2 Series On/Off and Floating Control Electric Non-Spring-Return Actuators Product Bulletin 3
Technical Specifications
M9116-AGx-2 Series On/Off and Floating Control Electric Non-Spring-Return Actuators
Power Requirements 20 to 30 VAC at 50/60 Hz or 24 VDC ±10%; 6.5 VA supply, Class 2
Input Signal 24 VAC at 50/60 Hz or 24 VDC
Input Signal Adjustments Factory Setting, Terminals 1 and 2, CW rotation; Terminals 1 and 3
Feedback Signal AGD: 135 ohm feedback potentiometer
AGE: 1,000 ohm feedback potentiometer
Auxiliary Switch Rating AGC: Two Single-Pole, Double-Throw (SPDT) switches rated at 24 VAC
1.5 A inductive, 3.0 A resistive; 35 VA maximum per switch, Class 2
Mechanical Output 140 lb·in (16 N·m) for one unit
(Running Torque)
Audible Noise Rating 45 dBA at 1 m
Rotation Range 0 to 90° in 5 degree increments, mechanically limited to 93°
Rotation Time 80 seconds at 50% rated load, 70 to 115 seconds for 0 to 140 lb·in (0 to 16 N·m)
Electrical Connection Screw terminals for 22 to 14 AWG; maximum of two 18, 20, or 22 AWG per terminal
Mechanical Connection 3/8 to 3/4 in. (10 to 20 mm) diameter round shaft or 3/8 to 5/8 in. (10 to 16 mm) square shaft
Enclosure NEMA 2, IP42
Ambient Conditions Operating: -4 to 122°F (-20 to 50°C); 0 to 95% RH, noncondensing
Storage: -40 to 186°F (-40 to 86°C); 0 to 95% RH, noncondensing
Dimensions (H x W x D) 7.09 x 3.94 x 2.54 in. (180 x 100 x 64.5 mm)
Shipping Weight 2.9 lb (1.3 kg)
Agency Compliance UL Listed, File E27734, CCN XAPX
CSA Certified, File LR85083, Class 3221 02
CE Mark, EMC Directive 89/336/EEC
The performance specifications are nominal and conform to acceptable industry standards. For application at conditions beyond these
specifications, consult the local Johnson Controls office. Johnson Controls shall not be liable for damages resulting from misapplication or
misuse of its products.
Building Technologies & Solutions
507 E. Michigan Street, Milwaukee, WI 53202
Metasys® and Johnson Controls® are registered trademarks of Johnson Controls
All other marks herein are the marks of their respective owners. © 2017 Johnson Controls
4 M9116-AGx-2 Series On/Off and Floating Control Electric Non-Spring-Return Actuators Product Bulletin
Published in U.S.A. www.johnsoncontrols.comПозиції каталогу з цим документом
Документ виробника, опублікований як довідковий матеріал на обладнання, яке ми постачаємо. Правовласник може попросити прибрати його — приберемо.