| Вид документа | Технічний бюлетень |
|---|---|
| Виробник | JCI |
| Код документа | m9109-ggx-2-series-proportional-electric-non-spring-return-actuators-submittal |
| Група обладнання | M9109 |
| Сторінок | 4 |
| Мова документа | англійська |
| Розмір файлу | 0.1 МБ |
Текст документа
Submittal Bulletin
Issue Date October 2017
M9109-GGx-2 Series Proportional
Electric Non-spring Return Actuators
The M9109-GGx-2 direct-mount electric actuators
operate on 24 VAC power and are available for use
with proportional controllers. These non-spring return
actuators are easily installed on a Variable Air Volume
(VAV) box and a damper with a steel shaft up to 1/2 in.
(13 mm) in diameter or 3/8 in. (10 mm) square. They
may be field mounted to a VG1000 Series ball valve
using the M9000-512 Valve Linkage Kit.
The M9109-GGx-2 models have an 80 lb·in (9 N·m)
running torque. They have a nominal 60-second travel
time for 90° of rotation at 60 Hz (72 seconds at 50 Hz)
with a load-independent rotation time. The
M9109-GGC-2 model is available with integral
auxiliary switches to perform switching functions at any
angle within the selected rotation range. Position
Figure 1: M9109 Non-spring Return Actuator
feedback is available through a 0 (2) to 10 VDC signal.
Features and Benefits
35 dBA Noise Rating Meets audibility requirements for open
ceilings
Synchronous Drive Provides constant rotation time independent
of load
Direct-shaft Mount with Simplifies installation and provides three-point
Single-screw Coupler shaft gripping
Magnetic Clutch Provides torque protection for the damper and
actuator
Jumper-selectable Simplifies installation
Rotation Direction
Adjustable Rotation Stops Allow application versatility with 30 to 90°
Clockwise (CW) or Counterclockwise (CCW)
rotation
1/2 in. National Pipe Thread Meets electrical code requirements and allows
(NPT) Threaded Conduit the use of armored cable
Opening
Manual Gear Release Simplifies setup and field adjustments
Output Position Feedback Provides simple, closed-loop control with
accurate position sensing
© 2017 Johnson Controls 1
Code No. LIT-1201457 www.johnsoncontrols.com
Application Operation
IMPORTANT: This device is not designed or IMPORTANT: The M9109-GGx-2 Series actuators
intended to be used in or near environments where are intended to control equipment under normal
explosive vapors or gases could be present or operating conditions. Where failure or malfunction of
environments where substances corrosive to the an M9109-GGx-2 actuator could lead to an abnormal
device’s internal components could be present. operating condition that could cause personal injury
or damage to the equipment or other property, other
The M9109-GGx-2 is used to position balancing, devices (limit or safety controls) or systems (alarm or
control, round, and zone dampers in typical HVAC supervisory) intended to warn of, or protect against,
applications. They are also used to position the blades failure or malfunction of the M9109-GGx-2 actuator
in a VAV box. The actuator can regulate the flow of hot must be incorporated into and maintained as part of
or chilled water, 50% glycol solutions, and low- the control system.
pressure steam when coupled to a 1/2 and 3/4 in.
Two-Way, and 1/2 in. Three-Way ball valve with A controller provides a control signal to the actuator
linkage. depending upon the desired movement of the
damper blade. This signal causes the motor to rotate
The M9109-GGx-2 mounts directly on the duct
in the proper direction and the damper blade to open
surface, round damper, or small rectangular damper
or close. The M9109-GGx-2 models have an auto
with an anti-rotation bracket and two sheet metal
shutoff to avoid excessive wear or drive time on the
screws (included). Additional linkages or couplers are
motor.
not required.
The actuator rotates at a nominal rate of 1.5° per
second (90° in 60 seconds) at 60 Hz input. The
actuator rotation is field adjustable from 30 to 90°.
Determine the actual rotation time for actuators using
less than 90° rotation and use that value with the
controller software. For example, 40 seconds is used
for 60° rotation.
Dimensions
See Figure 2 for the actuator dimensions.
4.0 Maximum Shaft 1.07
101.6 Dimensions 27.2 5.75
0.39 146
10 1.17
29.8
90 0
6 0 30
6.0 Maximum 0 90
152.4 30 60
Shaft
Dimensions Cover
0.39 to 0.50 Removal 1.88
4.3 10 to 12.7 48
109 2.13
54
4.2 Maximum 1.75/44.45
1.7 Clearance
106.5 45
Note: All dimensions are nominal Required for Anti-rotation Bracket
2.68
unless otherwise specified. Cover Removal Dimensions
68
Figure 2: Actuator and Anti-Rotation Bracket Dimensions, in. (mm)
2 M9109-GGx-2 Series Proportional Electric Non-spring Return Actuators Submittal Bulletin
Ordering Information
Table 1: Actuator Models and Accessories
Product Code
Description
Number
M9109-GGA-2 80 lb·in (9 N·m) electric non-spring return actuator for proportional control with 0(2) to 10 VDC feedback
M9109-GGC-2 80 lb·in (9 N·m) electric non-spring return actuator for proportional control with two SPDT 24 VAC
auxiliary switches and 0(2) to 10 VDC feedback
DMPR-KC003 Blade Pin Extension without Bracket for Johnson Controls D-1300 damper direct-mount applications
Note: Available with damper and may also be ordered separately
DMPR-KR003 Sleeve Pin Kit for Johnson Controls round dampers with a 5/16 in. (8 mm) diameter shaft
Note: Available with damper and may also be ordered separately
M9000-105 Pluggable 3-Terminal Block
M9000-106 Pluggable 4-Terminal Block
M9000-160 Replacement anti-rotation bracket for an M9109 actuator
M9000-512 Valve Linkage Kit for field mounting an M9109 actuator to a 1/2 and 3/4 in. two-way and three-way
VG1000 Series ball valve
M9109-GGx-2 Series Proportional Electric Non-spring Return Actuators Submittal Bulletin 3
Technical Specifications
Product M9109-GGx-2 Series Proportional Electric Non-spring Return Actuators
Power Requirements 20 to 30 VAC at 50/60 Hz; 3.2 VA supply, Class 2
Input Signal 0 to 10 VDC or 0 to 20 mA
Input Signal Adjustments (Voltage Input or Current Input):
Jumper Selectable: 0 (2) to 10 VDC or 0 (4) to 20 mA
Factory Setting: 0 to 10 VDC, CW rotation with signal increase
Action is jumper selectable Direct (CW) or Reverse (CCW) with signal increase.
Input Impedance Voltage Input, 150,000 ohms; Current Input, 500 ohms
Feedback Signal 0 to 10 VDC or 2 to 10 VDC for 90° (10 VDC at 1 mA)
Corresponds to input signal span selection.
Auxiliary Switch Rating GGC: Two Single-Pole, Double-Throw (SPDT) switches rated at 24 VAC,
1.5 A inductive, 3.0 A resistive, 35 VA maximum per switch, Class 2
Mechanical Output Running Torque: 80 lb∙in (9 N∙m)
Cycles 100,000 full cycles; 2,500,000 repositions rated at 80 lb∙in (9 N∙m)
Audible Noise Rating 35 dBA maximum at 1 m
Rotation Range Adjustable from 30 to 90° CW or CCW; mechanically limited to 93°
Rotation Time Nominal 60 seconds at 60 Hz and 72 seconds at 50 Hz for 90°
Electrical Connection 1/4 in. spade terminals (To order optional pluggable terminal blocks, see Table 2.)
Mechanical Connection 3/8 to 1/2 in. (10 to 12.7 mm) round steel shaft or 3/8 in. (10 mm) square steel shaft
Enclosure NEMA 2, IP32
Ambient Operating -4 to 125°F (-20 to 52°C); 90% RH maximum, noncondensing
Conditions
Ambient Storage -40 to 176°F (-40 to 80°C); 90% RH maximum, noncondensing
Conditions
Dimensions (H x W x D) 5.9 x 4.2 x 2.64 in. (150.1 x 106.5 x 67 mm)
Shipping Weight 2.4 lb (1.08 kg)
Agency Compliance UL Listed, File E27734, CCN XAPX
CSA Certified, File LR85083, Class 3221 02
CE Mark, EMC Directive 89/336/EEC
The performance specifications are nominal and conform to acceptable industry standards. For application at conditions beyond these
specifications, consult the local Johnson Controls office. Johnson Controls shall not be liable for damages resulting from misapplication or
misuse of its products.
Building Technologies & Solutions
507 E. Michigan Street, Milwaukee, WI 53202
Metasys® and Johnson Controls® are registered trademarks of Johnson Controls.
All other marks herein are the marks of their respective owners. © 2017 Johnson Controls.
4 M9109-GGx-2 Series Proportional Electric Non-spring Return Actuators Submittal BulletinПозиції каталогу з цим документом
Документ виробника, опублікований як довідковий матеріал на обладнання, яке ми постачаємо. Правовласник може попросити прибрати його — приберемо.